Rough Opening For 48 Sliding Closet Doors

The standard height is 80 inches which you can trim to fit your.

Rough opening for 48 sliding closet doors.

This will give you room to space the door frame off of the sub floor. These closet doors are not available as prehung units. You should add 2 1 2 to the height of the actual door. The space between the floor and the bottom of the door may vary depending on the type of flooring.

Get free shipping on qualified 48 x 80 sliding doors or buy online pick up in store today in the doors windows department. For the height of the rough opening you need to add 2 inches to the height of the door. The finished opening for bipass should be 63 which is why it s hard to convert to bifold in the future. Let me know if you have any other questions.

This allows for 1 2 inch thick drywall on both sides and at the top 80 inches for the doors and hardware and a 1 to 1 1 2 inch space under the door. A 6 foot wide closet opening is most common but you can install closet doors in an opening of just about any width. To get the total width multiply the width of each door by 2 and add 2 inches. The term framing here refers to installing the jambs into a rough opening for bypass or bifold doors.

So if each door measures 30 inches wide the width of the rough opening should be 62 inches. The rough opening should be 49 by 82 for a 48 by 80 inch door. These doors come in 24 28 30 32 and 36 inch widths. I would love to help.

Bipass hardware is usually acme or. Sets of bifolds are available in a variety of widths in multiples of. Just add 2 to the width of the actual door size. Wood jambs are normally thick so you would minus 1 off of the width and from the height.

82 1 2 would be ok too as you may want room for carpet. The height can be trimmed off the doors if you get it wrong but where i learned the rough opening was almost always 2 larger than the door size. You can adapt standard interior doors to use as sliding closet doors.